![]() ![]() Note: The shield does not come with headers installed we recommend the Arduino Stackable Header Kit. We also highly recommend a 12mm Coin Cell Battery, which fits into the GPS Shield’s battery holder. These two components should consume, about 30mA on average, but they may very occasionally spike to around 100mA. This voltage is regulated down to 3.3V, which is supplied to both the GPS module and the µSD card. The GPS Logger Shield’s main voltage supply is taken from the Arduino 5V header pin. It has way more resolution than a black and white 128圆4 display. ![]() This TFT display is big (2.8' diagonal) bright (4 white-LED backlight) and colorful (18-bit 262,000 different shades) 240x320 pixels with individual pixel control. The GPS module will stream constant position updates over a simple TTL-level serial port, which you can then log to a µSD card and/or use for other purposes.Įverything on the shield is highly configurable: A switch allows you to select the GPS module’s UART interface between either hardware or software ports, the µSD card operates over a hardware SPI port, which should be compatible with most Arduino layouts, and extra prototyping space should allow you to add those last, few components you need to complete your project. Spice up your Arduino project with a beautiful large touchscreen display shield with built in microSD card connection. The shield is based around a GP3906-TLP GPS Module – a 66-channel GPS receiver featuring a MediaTek MT3339 architecture and up to a 10Hz update rate. The SparkFun GPS Logger Shield equips your Arduino with access to a GPS module, µSD memory card socket, and all of the other peripherals you’ll need to turn your Arduino into a position-tracking, speed-monitoring, altitude-observing wonder logger. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |